What an electrical invoice documents
An electrical invoice records what was wrong, what was done and what went into the wall, since nobody can see the work afterwards.
For the customer it is proof of a repair, and for the next electrician it is the history of the circuit.
- Diagnosis, in hours, with what you found.
- Repair or installation labor, in hours or per device.
- Parts, each: breakers, receptacles, wire, boxes.
- Service call or trip fee.
- Permit fee, when one was pulled.
Describe the fault, not only the fix
"Replaced GFCI" tells the customer little.
"Dead outlets on the bathroom circuit traced to a failed GFCI in the garage, replaced" tells them why three rooms lost power and why it took an hour to find.
Use the description box on each line for that.
It is also your record if the same circuit trips again.
Labor and parts on an electrical bill
Start labor lines with "Labor:" and material lines with "Parts:" and the invoice prints a subtotal for each, with fees under other charges.
That split is useful at tax time too, because a state may treat electrical parts and labor differently.
Permits and inspections after the fact
Where the work needed a permit, say so on the invoice and note the inspection.
Washington State, for one, requires the inspection to be requested within three business days of finishing the work.
Rules vary by state and city.
A paid invoice with the permit number on it is what a homeowner hands to a buyer's inspector years later.
Larger electrical jobs
If the job was quoted, bill it at the quoted price and add approved changes as their own lines, then enter the deposit under "Amount already paid".
Your details carry over from the electrical quote template, since both remember them in the same browser.