What an HVAC invoice has to capture
An HVAC invoice records which piece of equipment was serviced, what failed and what was replaced, in enough detail to support a warranty claim later.
Service work is most of the trade's paperwork, and the same four kinds of lines cover nearly every call.
- Diagnosis, as labor.
- Parts replaced: capacitor, contactor, igniter, motor, each named.
- Repair labor, including the test afterwards.
- Service call fee.
- Refrigerant, when added, by type and weight.
Name the equipment
A home can have two or three systems.
Write which one you worked on, with its model and serial number, in the notes or in the job title.
When the same unit fails again, this is the line everyone looks for.
Readings worth writing down
Customers cannot judge an HVAC repair by looking at it.
A sentence in the notes with what you measured after the fix, such as the temperature split or the pressures, shows the system was tested and not just restarted.
It also gives the next technician a baseline.
Labor, parts and the fee
Begin labor lines with "Labor:" and parts lines with "Parts:" and the document subtotals each one, with the service call fee under other charges.
The sample on this page shows a no-cool call that way: one hour of diagnosis, two small parts and under an hour to fit and test them.
Refrigerant work
Adding or recovering refrigerant is regulated, and the technician must be certified under EPA Section 608.
Bill refrigerant by the pound and say what type it is.
If the system was low, say whether you found the leak.
Replacement jobs
A full system replacement is billed from its quote.
Use the quoted lines, add approved extras, and enter the deposit as the amount already paid.
If you have not written that quote yet, start with the HVAC quote template.