HVAC Quote Template

This quote is set up for HVAC replacement work: removal of the old system, the new equipment by size, the install, the startup test and the permit, with a deposit and a signature line. Enter your own models and prices and save the PDF.

Trade

Fills in example line items and terms. They are placeholders, not market prices: overwrite every one with your own.

Your business

Remembered in this browser for next time. Nothing you type here is uploaded or sent anywhere.

Customer

Quote details

How long you will hold this price. Clear it to leave the line off.

Printed under the job title. Leave it empty to leave it off.

Line items

Quantity times unit price, rounded to the cent on each line. Start a description with "Labor:" or "Parts:" and the document adds a subtotal for each.

Line 1

Line total $600.00

Line 2

Line total $7,200.00

Line 3

Line total $350.00

Line 4

Line total $150.00

Discount, tax and deposit

All optional. Leave them off and the document shows a plain total.

Leave at 0 for no tax line. Rates and what is taxable depend on your state and city.

Some states limit the deposit a contractor may ask for. Check the rule where you work.

Terms and notes

A starting point in plain words, not legal advice. Edit it to match how you work and the rules in your state.

Prints a place for the customer to sign and date to accept the quote.

Save your quote

5 lines still say "Example". The example descriptions and prices are placeholders, not market rates. Replace them with your own before you send this.

Your business name

Quote

No.
Q-1001

Prepared for

Customer name

Job

Example: Furnace and AC replacement

Line items
DescriptionAmount
Example: Remove existing furnace and condenser1 x $600.00$600.00
Example: New furnace and condenser, installed1 x $7,200.00$7,200.00
Example: Thermostat and startup test1 x $350.00$350.00
Example: Permit1 x $150.00$150.00
Subtotal
$8,300.00
Total
$8,300.00

Terms

This quote is a fixed price for the work listed above and holds until the date shown. Work outside this scope is priced separately and agreed in writing before it starts. The deposit, if one is shown, is due on acceptance and the balance is due on completion. The price assumes the existing ductwork, gas line and electrical supply are adequate for the new equipment. Equipment warranty terms come from the manufacturer.

To accept this quote, sign and date below and return a copy.

Customer signature
Date
How the totals are worked out

Each line is its quantity times its unit price, rounded to the cent. The subtotal is the sum of the lines.

A discount comes off the subtotal first. Tax is then charged on what is left of the lines marked taxable, so a discount lowers the tax too. The total is the subtotal, minus the discount, plus the tax.

A percentage deposit is a share of the total with tax included, and the balance is the total minus the deposit. All the math is done in whole cents and half a cent rounds up.

Your quote is built in this browser. Nothing is uploaded, and no account or email is needed.

Example: an HVAC quote, filled in

This sample HVAC quote is for "Heat pump replacement, 3-ton split system". It has 5 line items that add up to $10,230.00. A 10% deposit of $1,023.00 is due on acceptance, which leaves a balance of $9,207.00. The equipment line states the size in tons and that the outdoor and indoor units are a matched system, and refrigerant recovery from the old unit is written into the removal line. Every name, price and rate in it is a placeholder that shows the layout, not a market rate.

Your Heating and Cooling Company (sample)

100 Sample Street Your City, ST 00000 (555) 010-0100 office@example.com

License: Your license number

Quote

No.
Q-1001
Date:
November 20, 2026
Valid until:
December 20, 2026

Prepared for

Sample Customer

200 Example Avenue Your City, ST 00000 customer@example.com

Job

Example: Heat pump replacement, 3-ton split system

Line items
DescriptionAmount
Example: Remove existing condenser and air handler, recover refrigerant1 x $550.00$550.00
Example: 3-ton heat pump and air handler, matched system, installed1 x $8,400.00$8,400.00
Example: New line set, pad and disconnect1 x $780.00$780.00
Example: Thermostat, startup and airflow test1 x $320.00$320.00
Example: Permit and inspection1 x $180.00$180.00
Subtotal
$10,230.00
Total
$10,230.00
Deposit due on acceptance (10%)
$1,023.00
Balance
$9,207.00

Terms

This quote is a fixed price for the work listed above and holds until the date shown. Work outside this scope is priced separately and agreed in writing before it starts. The deposit, if one is shown, is due on acceptance and the balance is due on completion. The price assumes the existing ductwork, gas line and electrical supply are adequate for the new equipment. Equipment warranty terms come from the manufacturer.

Notes

Sample only. Every name, price and rate here is a placeholder to show the layout, not a market rate.

To accept this quote, sign and date below and return a copy.

Customer signature
Date

What an HVAC quote must identify

An HVAC quote is a fixed price for specific equipment, installed and tested, and the model numbers are what make it specific. Two systems of the same size can differ widely in price, so a quote that only says "new 3-ton system" cannot be compared with anything.

  • Removal: the old condenser, furnace or air handler, with refrigerant recovered.
  • Equipment: brand, model numbers, size and efficiency rating.
  • Install materials: line set, pad, disconnect, drain, flue or venting.
  • Controls: thermostat and wiring.
  • Startup: charge, airflow and safety checks.
  • Permit and inspection.

Matched equipment and sizing

Customers often ask two questions about HVAC replacements: are the indoor and outdoor units a matched pair, and how was the size chosen. Answer both on the quote. State the outdoor and indoor model numbers together, and say whether the size comes from a load calculation or from the unit being replaced.

What an HVAC price assumes

A replacement price takes the rest of the house as it is. Undersized returns, a leaking duct run, an old gas line or a full electrical panel can each add work. The terms in the template name those assumptions. If a new circuit is needed, that part normally sits on an electrician's quote, not yours.

Refrigerant and certification

Recovering refrigerant from the old system is part of removal, and the technician doing it must hold EPA Section 608 certification. Putting that in the removal line, as the sample on this page does, shows the old unit is not simply being cut loose.

Deposit, financing and warranty

Equipment is ordered for the job, so HVAC quotes commonly carry a deposit. Set it as a percentage or an amount, within what your state allows. Write the manufacturer's warranty and your own labor warranty as separate sentences, because they come from different companies.

After the install, or for a repair call, use the HVAC invoice template.

Common Questions

What should an HVAC quote include?

The equipment brand, model numbers and size, the efficiency rating, what is removed and what stays, the line set, pad, disconnect and thermostat, ductwork changes, the startup and airflow test, the permit, the warranty terms, and the assumptions about the existing ducts, gas line and electrical supply.

Do I need to mention refrigerant on an HVAC quote?

It helps to say that refrigerant from the old unit is recovered. Under EPA rules, technicians who maintain, service, repair or dispose of equipment that could release refrigerants into the atmosphere must be certified under Section 608. Stating that your technicians are certified answers a question careful customers ask.

How do I quote when the ductwork might not be adequate?

Inspect it first if you can. If you cannot, quote the equipment swap and say what it assumes. The HVAC terms in this template state that the price assumes the existing ductwork, gas line and electrical supply are adequate for the new equipment. Price duct changes as a separate line or a separate quote.

Can a homeowner cancel an HVAC quote signed at home?

Often there is a window. The FTC's Cooling-Off Rule gives a buyer until midnight of the third business day to cancel certain sales made at their home. The FTC lists exceptions, including sales needed to meet an emergency, and states have their own rules, so check before you order equipment the same day.

Should I offer more than one option on an HVAC quote?

Many contractors send two or three, each as its own quote with its own number, so the customer signs exactly one. Use 'Start the next quote' to keep your details, change the equipment line and price, and save each PDF.

Online Quote Form Setup

Let your website write the quote

You just worked out a price by hand. This puts your price list to work on your website: a customer answers a few questions, the form works out the price from your own rates, and they get an itemized quote by email while you get the request. We set it up from your price list and host it for you, so there is no monthly fee to us.

  • One quote request form for your business, with up to 10 questions and up to 15 priced items or options from your own price list
  • The price worked out from your rates the moment the customer submits, with no reply needed from you
  • An itemized quote emailed to the customer in your business name and colors, and an alert to you with every answer
  • Every request saved to a Google Sheet that you own
  • Added to your current website as an embed or a button, or delivered as its own page, with one round of changes
$395one time

Turnaround: Live within 5 business days of getting your price list and logo.

You pay on Stripe's secure checkout page. We never see your card number.