What an estimate is
An estimate is a written best guess at what a job will cost, made before all the facts are in.
It tells the customer roughly what to budget and tells you both what was assumed.
It is not a fixed price, and a good one says so in plain words.
What goes on an estimate
- Your business. Name, address, phone, email and license number.
- The customer and the job site. Who the estimate is for and where the work would happen.
- A number and dates. An estimate number, the date, and how long the figures hold.
- The work, line by line. Labor, materials, subcontractors, permits and disposal as separate lines with quantities, not one total.
- The estimated total and its range. One figure, and how far above or below it the final cost could land.
- Assumptions and terms. What you could not see, what you assumed about it, and that extra work needs approval first.
Give a range, not only a number
A single figure reads like a promise, whatever the heading says.
Set "The final cost could vary by" and the template prints an expected range under the estimated total, for example plus or minus 10 percent.
Choose the percentage from your own experience of similar jobs, and make it wider when more of the job is hidden.
The tool does not suggest one, because the right figure depends on your trade and the job.
When an estimate should become a quote
Move to a quote when the unknowns are gone: you have opened the wall, measured the roof or priced the materials with your supplier.
The quote template uses the same form with fixed-price wording and a line for the customer to sign.
Sending the quote before work starts means the number the customer agreed to is the number on the invoice.
Common mistakes on estimates
- Calling a fixed price an estimate, or the reverse. Pick the word that matches what you mean, and let the terms say the same thing.
- No assumptions. If the estimate assumes sound framing or working shutoff valves, write it down. That sentence is what you point to when the price moves.
- No allowance for what is likely. If rotted decking shows up on half your roofs, add an allowance line with a unit price so nobody is surprised.
- Taxing every line the same without checking. A job often mixes labor and materials, and tax may not apply to both. Confirm it for your state, then set the tax switch line by line.
- No expiry. Material prices move. Give the estimate a date it holds until.
- Example text left in. The presets are placeholders. The tool counts the lines that still say "Example" before you send anything.
Tax differs by state and by line
There is no rate the template could safely assume.
The Tax Foundation counts 45 states with a state-level sales tax and 38 that allow local sales taxes as well, so the rate depends on where the job is.
Enter your rate, then switch tax on or off for each line.
Ask your state's tax agency which lines of your kind of job are taxed: this page is not tax advice.
Estimate templates by trade
The builder on this page works for any business.
These pages open the same builder already set up for one trade, each with its own line items, sample and notes on what customers of that trade look for:
To measure the job first, start with the square footage calculator.
If you give estimates every week
The first number a customer asks for is usually a ballpark, and it does not need you at a keyboard.
A form on your own website can ask the questions you always ask and reply with a price built from your rates.
The free Form Kit shows how one works and lets you build it yourself, and the offer below is the same thing set up for you.